I recently updated a number of changes I have made and forgot to add this one. The way the trunk floor is set up I had to measure out and will have to fabricate quite a bit yet. So, I got the largest part of the project done awhile back - though it isn’t officially done yet.
The center piece will still need to have some reinforcement put into the panel with a bead roller, I just haven’t had time to get out to my buddy’s shop to do it. It will cover the gas tank and need to be removable for any servicing that needs to be done to the rear axle or underside of the car. Not a bit step, but every little bit helps. Fun, Fun, Fun.
Here it is with the beads rolled. Next step is to secure it to the brace with some screws.
And finally installed. I predrilled holes about every 4 inches or so and used self tapping metal screws to hold it down. I will put a soft gasket type material as well. Now I have to work on the side boxes to store the air compressors and mount the tank.
No comments:
Post a Comment